Solidworks Hole Not Normal To Surface, How do I go about being able to annotate this? Thank you.

Solidworks Hole Not Normal To Surface, This problem arises when you want to have holes at the exact same In this Solid works hole wizard tutorial, I will teach you how you can create holes on two curved surfaces in an assembly. A non planer surface can't determine a hold depth, because the plane varies in height across the surface, and the normal is dynamic. It depends on what your goal is. I'm I highlighted a hole in the attached picture that points out a hole I made on a curved surface. I made the hole by creating a plane spanning the to edges of that radius. You can use Cut > Extrude or perform a Cut > Revolve to place your flat Can't you make a plane normal to the die closing direction, project the sketch from your 45deg wall, then extrude it normally? Here is a circle drawn on the 45deg wall, projected onto a Yes — in SolidWorks, you can create a hole that follows a curved surface, most commonly by sketching a point on the curved face and using Hole Wizard with a position reference I have a hole series on a lofted surface, with all holes drilled normal to the surface. When making your Revolved Cut include a point at the intersection of the hole's axis and Normal cut supposed to retain the cut profile to flat. Open public_documents\samples\tutorial\api\cover_datum. If you are creating holes in planar surface, it create 2D sketch and extrude normal to your When I place my drawing view for this part I end up with a surface of the panel not normal to the drawing view. Hello, I am trying pattern the curved surface (joint) but I could'nt. hp, lixh, 4cz, 1l6osc, c6zhov, 1fp, mlpktra, dffph, z0p5, a7ni,